Inspect Spring, Starter Housing And Pulley - Briggs & Stratton 5 HP Troubleshooting & Repair Manual

5 HP Outboard • Troubleshooting & Repair Manual
Section 3 • Disassembly
Figure 61 — Rewind Starter Pulley
2. Lift out pawls
(Figure 61)
3. Rotate pulley until pulley feels free.
4. Carefully lift out pulley with spring
Figure 62 — Pulley With Spring

Inspect Spring, Starter Housing and Pulley

1. Inspect pulley for wear, cracks, rough edges
or burrs in pulley groove
(Figure 63) 1
on center hole .
3
2. Replace pulley if damaged or worn.
1
2
3
.
3
.
(Figure 62)
and wear
2
35
Figure 63 — Starter Pulley Spring
1
3. Inspect spring for broken ends, kinks and burrs.
Replace assembly if any of the above conditions exist.
4. Inspect starter housing for wear or sharp edges at
rope eyelet
(Figure 64)
inner spring anchor tab
Figure 64 — Starter Housing
4
5. Replace assembly if worn or damaged.
CAUTION
: Pulley and spring is serviced
as an assembly. Do not remove spring from
pulley.
2
3
, center pivot post , and
5 6
4
.
5
6
3