Table of Contents
Advertisement
3. Remove the throttle cable clamp
Figure 27 — Throttle Cable Clamp
3
4. Disconnect the throttle cable from the carburetor.
5. Disconnect the choke control rod
from the choke lever
Figure 28 — Port Side Components
6
6. Disconnect the fuel line
7. Remove two nuts
8. Lift the power head from the midsection. Disconnect
the neutral switch wires from the wiring harness.
9. Remove the power head.
(Figure 27)
4
(Figure 28)
.
7
at the fuel fitting.
6
, washers and bolts.
7
5 HP Outboard • Troubleshooting & Repair Manual
Blower Housing
.
1. Remove four screws
from front and two from rear of blower housing as
shown.
4
Figure 29 — Blower Housing Removal
4
A
Magnetron
™
5
NOTE:
The flywheel does not need to be removed
to service Magnetron™ ignition except to check the
keyway, flywheel key and oil seal. Replace any
damaged parts.
5
1. Remove blower housing.
2. Remove the spark plug wire from the spark plug.
3. Remove armature mounting screws
disconnect stop wire
Figure 30 — Armature Removal
2
24
Section 3 • Disassembly
(Figure 29A and B)
4
4
B
Ignition
(Figure 30)
. Lift off armature.
2
, two
,
1
1
Hide quick links:
Advertisement
Table of Contents
