Flywheel - Briggs & Stratton 5 HP Troubleshooting & Repair Manual

5 HP Outboard • Troubleshooting & Repair Manual
Section 3 • Disassembly
NOTE:
Elbow
(Figure 31)
removed except to be replaced if damaged.
Figure 31 — Plug Elbow

Flywheel

Remove the blower housing and rewind assembly to access
the flywheel.
CAUTION:
Do not strike flywheel to remove.
1. Use the correct flywheel holder
prevent the flywheel from turning.
Figure 32 — Holding The Flywheel
1
2. Use socket and breaker bar
nut.
3. To remove flywheel, use Tool (#19203), Flywheel
Puller .
(Figure 33)
does not need to be
to
(Figure 32) 1
2
to remove flywheel
2
25
Figure 33 — Flywheel Puller
NOTE:
Positioning retainer nuts
the puller screws is necessary to prevent damage to
the flywheel.
4. Thread flywheel nut onto crankshaft until top of nut is
flush with end of crankshaft threads.
5. Install the flywheel puller to the flywheel
6. Turn puller screws into flywheel puller holes until
screws bottom or puller contacts flywheel nut
.
(Figure 34) 4
Figure 34 — Remove Flywheel
6
3
7. Tighten puller nuts or screws
5
flywheel loosens.
NOTE:
If the screws
are too short, use two cylinder head bolts
(#94622), or two cylinder head studs ( #94776),
and two flat washers ( #225137) in place of original
screws.
(#19203)
3
on
(Figure 33) 3
.
5
4
equally until
6
on Flywheel Puller Tool
6
3