Powerwash Plus; One-Hand Adjuster - Kenmore 665.1280 Use And Care Manual

Cleaning Instructions
IMPORTANT: Do not use wire brush, scouring pad, etc., as they may damage the filters.
Rinse filter under running water until most soils are removed. If you
have hard-to-remove soils or calcium deposits from hard water, a
softbrush maybe required.
Filter ReinstallationInstructions
1. Noting the previous illustrations, place the Lower Filter under the Locating Tabs in the
bottom of the dishwasher so the round opening for the Upper Filter Assembly lines up with
the round opening in the bottom of the tub.
2. Insertthe UpperFilterAssemblyinto the circularopening in the LowerFilter.
3. Slowly rotate the filter clockwise until it drops into place. Continue to rotate until the filter
is locked into place. If the filter is not fully seated (still turns freely), continue to turn the
filter clockwise until it drops and locks into place.
Toreplace UpperFilterAssernb_
IMPORTANT: Toavoid damage to dishwasher, do not operate your dishwasher without the ULTRACLEAN
TM
filters properly installed.
Be sure the Lower Filter is securely in place and the Upper FilterAssembly is locked into place. Ifthe Upper FilterAssemblyturns
freely, it is not locked into place.
360 POWERWASHPLUS®
The 360 Powerwash Plus®system offers advanced cleaning technology providing optimal water coverage. This technology enables the spray
arms to turn in both directions while detecting if there are any items obstructing the spray arm from spinning. When the spray arms are
obstructed the system will detect and force the spray a rm to rotate inthe opposite direction allowing compIete coverage of the dishwasher load.
ONE-HAND ADJUSTER
To adjustthe height of the upper rack using the One-Hand Adjuster:
1. Pullthe upperrackfullyoutofthe dishwasher. Make sure the
lower rack is pushed fully into the dishwasher.
2. Press the handle downward until it stops. You will hear2 clicking
sounds. This assures that both sides of the rack are locked.
3. Release the handle.
4. To adjustthe height of the upper rack again, repeat steps 1 - 3.
NOTE: If one side of the rack is tilted down, lift the rack on the side
tilted down. You will hear a clicking sound when the rack returns to
level.
Adjust rack height Levelrack
10