Data View Page - GRAUPNER POLARON PRO Operating Manual

BALANCE MODE 1
BALANCE MODE 1
This page (above, left) shows the basic date of the battery.
BALANCE MODE 2
This page (above, center) shows the cell voltage and internal impedance values.
BALANCE MODE 3
This page (above, right) displays multiple parameters.
CENTER VOLTAGE(VC)
RANGE VOLTAGE(VR)
MANUAL
AUTO
CELL VOLTAGE
Tap the DATA icon on the main page to access the data view mode. There are 3 view modes. After activating the buttons,
the data can be programmed by tapping the DEC/INC buttons. In the Cycle data and Graph data modes, the data can
be accessed. In the Normal data mode, the parameters can not be programmed.
BALANCE MODE 2
The voltage of the center in the Y axis.
The voltage range of every section in the Y axis.
The graph can be manually operated. Tap the data box to activate. Tap the DEC/INC
buttons to program the parameters. The Center Voltage and Range Voltage can be
activated and programmed using the manual setup.
This mode performs an automatic setup of the graph for the operation.
Each cell voltage is activated and checked.
Displays the cell voltage. Tapping activates this paramter, allowing the cell data
to be checked.
17.

DATA VIEW PAGE

Tap the DATA icon to check the charge/discharge data
on the main page.
Center voltage
Range voltage
Cell Voltage
Manual / Auto
BALANCE MODE 3
69