Network Menu List; Setting The Ethernet Speed; Setting The Tcp/Ip Protocol - Toshiba e-Studio 2505H User Manual

Network Menu List

You can set various network functions.
For instructions on how to display the NETWORK menu, see the following page:
P.119 "User Functions Menu List"
NETWORK
COMPLETE
ETHERNET
TCP/IP
P.117 "Setting the Ethernet speed"
P.117 "Setting the TCP/IP protocol"
P.118 "Setting the HTTP network service"
Once the network has been set up, exit from "USER FUNCTIONS" menu by pressing [CANCEL] or [USER
FUNCTIONS] button. When "APPLY AND REBOOT?" message appears, select "YES", and then press [OK]. The
equipment is automatically rebooted and the network settings are applied.

Setting the Ethernet speed

You can specify the Ethernet speed.
ETHERNET
AUTO
10MBPS HALF DUPLEX
10MBPS FULL DUPLEX
Item name
AUTO
10MBPS HALF DUPLEX
10MBPS FULL DUPLEX
100MBPS HALF DUPLEX
100MBPS FULL DUPLEX
If the network is not stable, turn the power of the equipment OFF and then back ON.

Setting the TCP/IP protocol

You can set the TCP/IP protocol that is commonly used in most network systems. When using Web-based utilities such as
TopAccess or network features of this equipment such as network printing and network scanning, you are required to set
the TCP/IP protocol.
In the TCP/IP setting operation, you can select the addressing mode, as well as assign the IP address, subnet mask and
default gateway (when manually assigned).
Select the desired combination of communication speed and transmission method.
5 VARIOUS FUNCTIONS
Description

Network Menu List

117