Connecting Power To The Chargebase; Charging The Main Battery; To Power A Terminal And Charge Its Main Battery; Mounting The Chargebase - Honeywell Dolphin 75e User Manual

Connecting Power to the ChargeBase

A/C Power Cord
1. Plug the A/C power cord into the power adapter.
2. Plug the power cable into the power connector on the back of the ChargeBase.
3. Plug the A/C power cord into a grounded power source.
4. The base is ready to begin charging terminals.

Charging the Main Battery

The base provides power to the Dolphin terminals and allows charging of the batteries in the terminals. The battery of each
terminal charges in 4 hours for the standard battery or 6 hours for the extended battery. The intelligent battery charging
system incorporated into all Dolphin terminals prevents overcharging, which means that Dolphin terminals may be seated
in the base indefinitely without damage to the terminals, batteries, or the base.
For more information about Honeywell battery packs and how to check battery power level in your terminal, refer to
(page 2-8).

To Power a Terminal and Charge its Main Battery

Ensure all components are dry prior to mating terminals/batteries with peripheral devices. Mating wet
components may cause damage not covered by the warranty.
1. Install the battery in the terminal, see
2. Insert the Dolphin terminal into one of the four terminal wells. The Dock LED for the well illuminates blue. Charging
begins immediately if required by the Dolphin terminal.
Note: When the terminal is docked, the Battery Icon changes from
external power. Battery charging occurs in the background. When the Dolphin is removed from the base, the battery
icon indicates the charge level of the battery, see
We recommend use of Honeywell Li-ion battery packs. Use of any non-Honeywell battery may result in damage
not covered by the warranty.

Mounting the ChargeBase

Set the base on a dry, stable surface, such as a desktop or workbench near an electrical outlet. Be sure to provide enough
workspace with good lighting for the user to view and operate the Dolphin terminal while it is in the base. When choosing a
location, keep in mind that the mounting location must allow users to see the LEDs and provide easy access to the terminal
wells and the power jack.
11 - 4
Power LED
Power Adapter
Install the Battery on page
Common Status and Notification Icons
Power Connector Cable
1-1.
to indicating the terminal is running on
Battery
on page 1-8.