Honeywell Dolphin 75e User Manual page 117

DOCK LEDs
The Dock LED indicates if the terminal is properly seated in the charging well. Each well has a dedicated Dock LED, which
illuminates blue when a terminal is properly seated in the charging well.
Back Panel
RJ45 Ethernet Ports
The Net Base contains two RJ45 Ethernet ports. You can connect the Net Base to an Ethernet-compliant device to facilitate
Ethernet communication to and from the terminal by plugging a standard CAT-5 Ethernet cable into one of the two Ethernet
ports provided. The second RJ45 Ethernet port can be used for connection to an additional device such as a printer,
workstation, eBase, or another Net Base.
Note: The Net Base does not use a Spanning Tree Protocol (STP). When both RJ45 Ethernet ports are used, do not
connect both Net Base interfaces to the same layer 2 LAN.
Each RJ45 Ethernet port has a dedicated green and yellow status LED.
Status
No Ethernet Link
10Mbps Ethernet Connection Established
100Mbps Ethernet Connection Established
Data transfer in progress
Note: The terminal and Ethernet link must be set up properly to allow the terminal to communicate to other devices and/or
the Internet. For more information, see
DC Power Jack
This connector receives input from the power adapter. Plug the power connector cable from the power adapter into this
connector, see Power.
Yellow LED (Qty. 1 Per Port)
Port 1: 10/100Mbps RJ45 Ethernet Port
Port 2: 10/100Mbps RJ45 Ethernet Port
Establishing Ethernet Communication
Green LED (Qty. 1 Per Port)
Yellow LED
Off
Off
On
Connection Speed Dependent
(see above)
DC Power Jack
Green LED
Off
On
On
Flashing
on page 12-5.
12 - 3