Honeywell Dolphin 75e User Manual page 47

3. Touch Scan or press the Scan button (center button).
If you touch and hold Scan a red beam appears to assist with aiming; see
Note: By default, the left and right side buttons also trigger the scan/imager.
4. The bar code is decoded and the results appear on the screen.
Decode Results
Scan Statistics
See Configuring the Scan Demo
Application on page 3-4.
Touch to clear scan results.
Automatic Scanning
Enable Automatic scan mode to activate the imager for continuous scanning without requiring the operator to touch
Scan for each bar code presented in the field of view of the imager.
1. Open the Scan Demo
2. Swipe left or touch Settings, and then select Scan.
3. Change the Scan Mode to Automatic.
4. Use the slider adjustment under Automatic Interval to set the number of seconds (0 to 30) between scan attempts.
5. Press the Back button
6. Touch Scan on the screen to activate the imaging engine. Once activated, the imager automatically scans and
decodes bar codes presented in the field of view based on the Automatic Interval set.
To disable the feature set the Scan mode back to Normal.
Continuous Scanning
Enable Continuous scan mode to activate the imager for continuous scanning when you press and hold the Scan
button.
1. Open the Scan Demo
.
to return to the Scan screen.
.
Aiming Beam on page 3-5.
Swipe left or select Settings to
adjust scan options, symbology
types, and profiles.
3 - 3