Servicing Notes - Sony STR-DA5400ES Service Manual

STR-DA5400ES
QQ
3 7 63 1515 0
UNLEADED SOLDER
Boards requiring use of unleaded solder are printed with the lead-
free mark (LF) indicating the solder contains no lead.
(Caution: Some printed circuit boards may not come printed with
the lead free mark due to their particular size)
: LEAD FREE MARK
Unleaded solder has the following characteristics.
• Unleaded solder melts at a temperature about 40 °C higher
than ordinary solder.
Ordinary soldering irons can be used but the iron tip has to be
applied to the solder joint for a slightly longer time.
Soldering irons using a temperature regulator should be set to
about 350 °C.
Caution: The printed pattern (copper foil) may peel away if
the heated tip is applied for too long, so be careful!
• Strong viscosity
Unleaded solder is more viscous (sticky, less prone to fl ow)
than ordinary solder so use caution not to let solder bridges
occur such as on IC pins, etc.
• Usable with ordinary solder
It is best to use only unleaded solder but unleaded solder may
also be added to ordinary solder.
UPDATE OF SOFTWARE OF IC2513 ON THE CON-
TROL BOARD, IC3610 ON THE D VIDEO BOARD AND
IC5208 ON THE DSP BOARD
Perform operation of the following when the update of software
of the IC2513 on the CONTROL board, IC3610 on the D VIDEO
board and IC5208 on the DSP board is necessary.
TE
L 13942296513
Connect:
J1499
for PC
Procedure:
1. Connect J1499 on the MAIN board and PC by using the RS-
232C cable.
2. Turn on the main power.
3. The update is executed by using PC.
4. When the update ends, turn off the main power.
5. Remove the RS-232C cable from the J1499 on the MAIN
board and PC.
ERROR MESSAGES
If there is a malfunction, the display shows a code of two numbers and a message. You can check the condition of the system by the message.
Refer to the following table to solve the problem.
messages
PROTECTOR
www
.
4
http://www.xiaoyu163.com
SECTION 1

SERVICING NOTES

cause and response
Irregular current is output to the speakers, or the upper panel of the receiver is covered with something.
The receiver will automatically turn off after a few seconds. Cheack the speakers connection and turn
on the power again.
x ao u163
y
i
http://www.xiaoyu163.com
2 9
8
MODEL IDENTIFICATION
– Back Panel –
Model
US and Canadian models
AEP model
Continental European, East Euro-
pean and Russian models
UK model
NOTE OF REPLACING THE IC3601 ON THE
D VIDEO BOARD
Replacement of IC3601 on the D VIDEO board used in this set
requires a special tool.
NOTE OF REPLACING THE IC3511, IC3513 AND
IC3514 ON THE D VIDEO BOARD
IC3511, IC3513 and IC3514 on the D VIDEO board cannot ex-
change with single. When these parts on the D VIDEO board are
damaged, exchange the entire mounted board.
Q Q
NOTE OF REPLACING THE IC5002 AND IC5202 ON
3 6 7 1 3 1 5
THE DSP BOARD
IC5002 and IC5202 on the DSP board cannot exchange with sin-
gle. When these parts on the DSP board are damaged, exchange the
entire mounted board.
co
.
9 4 2 8
PART No.
Part No.
3-296-122-0[]
3-296-122-1[]
3-296-122-2[]
3-296-122-5[]
0 5 8 2 9 9 4 2 8
m
9 9
9 9