Table of Contents
Advertisement
NOTES ON HANDLING THE OPTICAL PICK-UP
BLOCK OR BASE UNIT
The laser diode in the optical pick-up block may suffer electrostatic
break-down because of the potential difference generated by the
charged electrostatic load, etc. on clothing and the human body.
During repair, pay attention to electrostatic break-down and also
use the procedure in the printed matter which is included in the
repair parts.
The flexible board is easily damaged and should be handled with
care.
NOTES ON LASER DIODE EMISSION CHECK
The laser beam on this model is concentrated so as to be focused on
the disc reflective surface by the objective lens in the optical pick-
up block. Therefore, when checking the laser diode emission,
observe from more than 30 cm away from the objective lens.
UNLEADED SOLDER
Boards requiring use of unleaded solder are printed with the lead-
free mark (LF) indicating the solder contains no lead.
(Caution: Some printed circuit boards may not come printed with
the lead free mark due to their particular size)
: LEAD FREE MARK
Unleaded solder has the following characteristics.
• Unleaded solder melts at a temperature about 40 °C higher
than ordinary solder.
Ordinary soldering irons can be used but the iron tip has to be
applied to the solder joint for a slightly longer time.
Soldering irons using a temperature regulator should be set to
about 350 °C.
Caution: The printed pattern (copper foil) may peel away if
the heated tip is applied for too long, so be careful!
• Strong viscosity
Unleaded solder is more viscou-s (sticky, less prone to flow)
than ordinary solder so use caution not to let solder bridges
occur such as on IC pins, etc.
• Usable with ordinary solder
It is best to use only unleaded solder but unleaded solder may
also be added to ordinary solder.
RELEASING THE DISC TRAY LOCK
The disc tray lock function for the antitheft of an demonstration
disc in the store is equipped.
Releasing Procedure :
Press two buttons of
and
A
The message "UNLOCKED" is displayed and the tray is unlocked.
Note: When "LOCKED" is displayed, the tray lock is not released by turning
power on/off with the
I/1
NOTE OF REPLACING THE DMB07 BOARD
When replacing the DMB07 board, since the adjustment value is
not set up correctly, "Drive Auto Adjustment" can't be performed.
In this case, initialize Memory in the following procedures.
Procedure:
1. Set the test mode. (See page 15)
2. Press the [2] key of the remote commander, and set the "DRIVE
MANUAL OPERATION". (See page 18)
3. Press the [6] key of the remote commander, and set the "2-6,
Memory Check". (See page 20)
4. Press the [CLEAR] key of the remote commander, and initialize
Memory.
SECTION 1
SERVICING NOTES
simultaneously for five seconds.
x
button.
• MODEL IDENTIFICATION
– Back Panel –
PART No.
MODEL
AEP, UK models
Korean model
Singapore model
Hong Kong model
Australian model
Russian model
HCD-SB500W
PART No.
2-067-992-0[]
2-067-992-1[]
2-067-992-2[]
2-067-992-3[]
2-067-992-4[]
2-067-992-5[]
5
Advertisement
Table of Contents
