Mira JUMP Installation And User Manual page 20

Operating Instructions
Turn the shower on
1. Switch on the electrical supply at the
double pole switch. The power light is
illuminated.
2. Turn the shower on by pressing the
start/stop button.
Select heater setting
3. Turn the heater control to High. Allow
15-20 seconds for warm water to
reach the showerhead.
For electrical economy, set the
heater control to Eco. This setting
will provide sufficient power during
the summer when the mains water
temperature is warmer.
For a cold shower, set the heater
control to Low.
Caution! Care is required when
adjusting flow or temperature,
make sure that the temperature has
stabilised.
Always check the water temperature
before entering the shower.
Adjust the showering temperature
4. Adjust the shower temperature by
turning the temperature control as
necessary. Turn clockwise for hotter
water and anti-clockwise for cooler
water.
Allow 10-15 seconds for the shower
to fully adjust to the required
temperature.
Note! It is normal for the flow rate
(shower force) to change when the
temperature is changed.
Rapid/Excessive movement of the
flow and or temperature control levers
may result in momentary unstable
blend temperatures.
+
_
20