Setting Example - FujiFilm Xerox Phaser 6270 User Manual

Setting Example:

Changing the Power Saver Mode Setting
Use the following procedure to set a value on the control panel.
In this example, we will set [Low Power Timer] (an interval at which the printer switches to
the Low Power mode) to [60 Minutes].
1. Press the <Menu> button to display the
menu screen.
2. Press the < > button until [Admin Menu] is
displayed.
Note
• If you went past the desired item, return to the item by
pressing the <
3. Press the < > or <Eject/Set> button to
accept the selection.
Move on to the lower hierarchy.
Note
• If you pressed the <
return to the previous screen by pressing the <
button.
• To start over from the beginning, press the <Menu>
button.
4. Press the < > button until [System
Settings] is displayed.
5. Press the < > or <Eject/Set> button to
accept the selection.
[Low Power Timer] is displayed.
6. Press the < > or <Eject/Set> button to
accept the selection.
The current set value appears.
7. Press the < > or < > button to display [60
Minutes].
Note
• Holding down the <
the options in a circular fashion.
8. Press the <Eject/Set> button to accept the
value.
9. The setting is now complete.
Press the <Menu> button to return to the
[Ready to Print] screen.
64
5 Control Panel Menus
> button.
> button on the wrong item,
> or < > button scrolls through
Menu
Report / List
Menu
Admin Menu
Admin Menu
Wired Network
>
Admin Menu
System Settings
System Settings
Low Power Timer
Low Power Timer
3 Minutes*
Low Power Timer
60 Minutes
Low Power Timer
60 Minutes*
Ready to Print