Printer/Cartridge Installation And Removal; Printer/Cartridge Installation - Magtek EXCELLA STX Installation And Operation Manual

Hide thumbs Also See for EXCELLA STX:

Table of Contents

Excella STX Installation and Operation

PRINTER/CARTRIDGE INSTALLATION AND REMOVAL

To install the Printer/Cartridge, refer to Figure 2-4 and perform the following:

1. Ensure the printer latch is down and locate the guide pins on the Printer/Cartridge and the

guide holes in the Printer Base (Inset).

2. Slide the guide pegs into the guide holes as indicted in Figure 2-4.

3. Raise the latch so that it touches the Printer/Cartridge.

4. Press the latch into the lock position, and move the Cartridge slightly to ensure it is locked.

5. Perform steps 1 through 4 on the other Printer/Cartridge located inside of the exit path.

To remove the Cartridge, pull the latch down, and slide the Cartridge out.

Ensure both latches are up before installing either or both covers,

no matter if the Printer/Cartridges are installed or not.

Caution

Table of Contents

Show Quick Links

Table of Contents

Do you have a question about the EXCELLA STX and is the answer not in the manual?