Table of Contents
Advertisement
USB board
Description
USB board (includes cable)
Before removing the USB board, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4.
Remove the bottom cover (see
To remove the USB board:
1.
Position the bottom cover upside-down.
2.
Remove the Phillips PM2.0×3.0 screw (1).
3.
Lift up the ribbon cable to detach it from the bottom cover. The cable is held in place with double-sided
tape.
4.
Lift up the rear of the board and remove the board from the bottom cover (2).
Reverse this procedure to install the USB board.
Bottom cover on page
23).
Spare part number
755734-001
Component replacement procedures
27
Advertisement
Table of Contents
