Table of Contents
Advertisement
Power connector cable
Description
Power connector cable
Before removing the power connector cable, follow these steps:
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
4.
Remove the bottom cover (see
5.
Remove the battery (see
Remove the power connector cable:
NOTE:
The right bracket is also held in place by screws that were removed when the bottom cover was
removed.
1.
Remove the black Phillips PM2.5×6.0 screw (1) that secures the right bracket to the computer.
2.
Open the display assembly right hinge (2) as far as it will open.
3.
Remove the right hinge bracket from the computer (3).
4.
Disconnect the power connector cable (4) from the system board.
5.
Remove the power connector (5) from the computer.
Reverse this procedure to install the power connector cable.
Bottom cover on page
Battery on page
34).
23).
Component replacement procedures
Spare part number
755727-001
37
Advertisement
Table of Contents
