Canon i-SENSYS LBP5300 Series Service Manual page 28

Chapter 1
Item
TCP/IP SETTINGS
IP MODE
PROTOCOL
DHCP
BOOTP
RARP
IP SETTINGS
IP ADDRESS
SUBNET MASK
GATEWAY ADDRESS
DNS
PRIMARY ADD.
SECONDARY ADD.
WIN
S
ARP
/
PIN
G
FTP
FTP PRINT
FTP SETTINGS
LPD PRINT
RAW PRINT
BMLinkS
IPP PRINT
HTTP
SNTP
RESPONSE
IP ADD.RANGE
REJECT RX/PRT
REJECT ADD.SET.
PERMIT RX/PRT
PERMIT ADD.SET.
REJ SET/BROWSE
REJECT ADD.SET.
PMT SET/BROWSE
PERMIT ADD.SET.
MAC ADDRESS SET
PERMIT RECEIVE
PERMIT ADD.SET.
AppleTalk
SMB
SMB SERVER
SMB
SNMP
SPOOLER
START WAIT TIME
REMOTE UI SET.
REMOTE UI
1-12
Setting
MANUAL*, AUTO
OFF*, ON
OFF*, ON
OFF*, ON
0.0.0.0*
0.0.0.0*
0.0.0.0*
0.0.0.0*
0.0.0.0*
ON, OFF*
ON*, OFF
ON*, OFF
ON*, OFF
ON*, OFF
ON*, OFF
OFF*, ON
ON*, OFF
ON*, OFF
ON*, OFF
ON*, OFF
OFF*, ON
reject IP address 1 through reject IP address 8
OFF*, ON
permit IP address 1 through permit IP address 8
OFF*, ON
permit IP address 1 through permit IP address 8
OFF*, ON
permit IP address 1 through permit IP address 8
OFF*, ON
permit MAC address 1 through permit MAC address 50
ON*, OFF
OFF*, ON
OFF*, ON
ON*, OFF
OFF*, ON
0 to 300 (0*)
ON*, OFF
Notes
PROTOCOL is displayed only when IP MODE is
set to AUTO.
REJECT ADD.SET. and PERMIT ADD.SET. are
displayed only when REJECT RX/PRT, PERMIT
RX/PRT, REJ SET/BROWSE, PMT SET/
BROWSE, or PERMIT RECEIVE is set to ON.
REJECT ADD.SET. and PERMIT ADD.SET. are
displayed only when REJECT RX/PRT, PERMIT
RX/PRT, REJ SET/BROWSE, PMT SET/
BROWSE, or PERMIT RECEIVE is set to ON.
REJECT ADD.SET. and PERMIT ADD.SET. are
displayed only when REJECT RX/PRT, PERMIT
RX/PRT, REJ SET/BROWSE, PMT SET/
BROWSE, or PERMIT RECEIVE is set to ON.
REJECT ADD.SET. and PERMIT ADD.SET. are
displayed only when REJECT RX/PRT, PERMIT
RX/PRT, REJ SET/BROWSE, PMT SET/
BROWSE, or PERMIT RECEIVE is set to ON.
REJECT ADD.SET. and PERMIT ADD.SET. are
displayed only when REJECT RX/PRT, PERMIT
RX/PRT, REJ SET/BROWSE, PMT SET/
BROWSE, or PERMIT RECEIVE is set to ON.
This item is displayed only when NETWORK in the
I/F ONNECTION options is set to ON.
SMB is displayed only when an optional hard disk
is installed, HARD DISK is set to ON, and SMB
SERVER is set to ON.
This item is displayed only when NETWORK in the
I/F CONNECTION options is set to ON.
This item is displayed only when NETWORK in the
I/F CONNECTION options is set to ON, an
optional hard disk is installed, and HARD DISK is
set to ON.
This item is displayed only when NETWORK in the
I/F CONNECTION options is set to ON.
This item is displayed only when NETWORK in the
I/F CONNECTION options is set to ON.