Outgoing Announcements - AT&T E2812B User Manual

Press to stop recording.
1.
ANNC
"Announcement.
Press PLAY or press
RECORD."
2.
PLAY/
(Plays announce-
ment previously
recorded).
- OR -
1.
ANNC
"Announcement.
Press PLAY or press
RECORD."
2.
RECORD
"Record after the
tone. Press STOP
when you are
done."
3.
Speak into microphone.
Microphone
4.
PLAY
(Announcement
is played back).
5.
ANNC
to exit announcement record-
ing.
Answering system operation

Outgoing announcements

The outgoing announcement is the message call-
ers hear when calls are answered by the answering
Elapsed
recording
system.
time (sec-
onds).
The telephone is factory set with an announcement.
If the telephone is set up to record messages, it
answers calls with "Hello. Please leave a message
after the tone." You can use this announcement, or
replace it with a recording of your own voice.
To play your outgoing announcement
Press ANNC
Press PLAY or press RECORD." Press
You will hear the outgoing announcement. Press
STOP
ANNC to exit the announcement menu.
To record your outgoing announcement
Press ANNC, then you will hear "Announcement.
Press PLAY or press RECORD." Press RECORD and
begin speaking after you hear "Record after the tone.
Press STOP when you are done." Speak facing the
telephone base from about nine inches away. Press
announcement will be played back. Press ANNC to
exit the announcement menu.
Elapsed time (in seconds) will be shown in the
message window when recording. You can
record an announcement up to 90 seconds long.
Announcements shorter than two seconds long will
not be recorded.
To delete your outgoing announcement
Press ANNC, then you will hear "Announcement.
Press PLAY or press RECORD." Press
to begin playback. Press
delete your announcement. Press ANNC to exit the
/STOP
announcement menu.
When your announcement is deleted, calls will
be answered with the factory set announcement
described above.
then you will hear "Announcement.
,
when you are done. Your recorded
/STOP
PLAY
35
PLAY/
during playback to
DELETE
.
PLAY/
STOP
STOP