Dial Type - AT&T E2812B User Manual

>
DIRECTORY
>

DIAL TYPE

DIAL TYPE: TONE
Telephone operation
Handset settings
To cancel an operation, back up to the previ-
ous menu, or exit the menu display press
OFF/ . To return to the idle mode press and
CLEAR
hold OFF/
CLEAR
Dial type
In this menu, you can choose TONE or PULSE
(rotary) dialing. The factory default setting is TONE.
Change this to PULSE only if you do not have
touch-tone dialing service.
1. Press MENU/
feature menu.
2. Use the
CID/-VOLUME
to the DIAL TYPE menu, press
enter the menu when it is highlighted with a >
symbol.
3. Press the
CID/-VOLUME
select TONE or PULSE.
4. Press /SELECT to save your preference and
MENU
be returned to the feature menu.
NOTE: If you have more than one handset registered, dial
type change made on any one handset will apply to all.
Temporary ring silencing
Press OFF/
CLEAR
ephone is ringing to silence the ringer temporarily.
This will silence the ringer without disconnecting
the call. The next incoming call will ring normally
at the pre-set volume.
NOTE: If there is more than one handset in use, all hand-
sets ring with an incoming call except those with the vol-
ume turned off. Press
one handset will only silence the ringer of that particular
handset but the other handset(s) will continue to ring.
21
.
in idle mode to enter the
SELECT
or
DIR
or
DIR
or MUTE/
DELETE
OFF/
CLEAR
to scroll
/VOLUME+
/SELECT to
MENU
to
/VOLUME+
while the tel-
or MUTE/ on
DELETE