Outgoing Announcements - AT&T E2913B User Manual

Press to stop recording.
.
ANNC
"Announcement.
Press PLAY or press
RECORD."
2.
PLAY/
(Plays announce-
ment previously
recorded).
- OR -
.
ANNC
"Announcement.
Press PLAY or press
RECORD."
2.
RECORD
"Record after the
tone. Press STOP
when you are
done."
3.
Speak into microphone.
Microphone
4.
PLAY
(Announcement
is played back).
5.
ANNC
to exit announcement record-
ing.
Answering system operation

Outgoing announcements

Elapsed
recording The outgoing announcement is the message callers hear
time (sec-
when calls are answered by the answering system.
onds).
The telephone is factory set with an announcement.
If the telephone is set up to record messages, it
answers calls with "Hello. Please leave a message
after the tone." You can use this announcement, or
replace it with a recording of your own voice.
To play your outgoing announcement
Press ANNC
Press PLAY or press RECORD." Press
announcement. Press ANNC to exit the announce-
ment menu.
STOP
To record your outgoing announcement
Press ANNC, then you will hear "Announcement.
Press PLAY or press RECORD." Press RECORD and
begin speaking after you hear "Record after the
tone. Press STOP when you are done." Speak
facing the telephone base from about nine
inches away. Press
done. Your recorded announcement will be played
back. Press ANNC to exit the announcement menu.
Elapsed time (in seconds) will be shown in
the message window when recording. You can
record an announcement up to 90 seconds long.
Announcements shorter than two seconds long
will not be recorded.
To delete your outgoing announcement
Press ANNC, then you will hear "Announcement.
Press PLAY or press RECORD." Press
to begin playback. Press
to delete your announcement. Press ANNC to exit
/STOP
the announcement menu.
When your announcement is deleted, calls will
be answered with the factory set announcement
described above.
then you will hear "Announcement.
,
PLAY . You will hear the outgoing
/STOP
37
STOP when you are
PLAY/
DELETE during playback
PLAY
/STOP