IBM eServer 342 xSeries Installation Manual page 25

Terminator card
VRM 2
VRM connector
6. Store the terminator card in a safe place in the static-protective package.
7. Install the microprocessor.
8. Install the voltage regulator module (VRM) included in the microprocessor kit.
Attention: When installing or replacing a VRM, use only a VRM specified for use
with the xSeries 342 server. Use of other VRMs might cause your server to
overheat.
9. Remove the clear plastic liner from the thermal material on the underside of the
fan sink and discard.
10. Set the fan sink into place.
Fan sink
(Remove thermal tape liner on installation)
Microprocessor 2
Microprocessor 1 location
VRM 1
Fan sink
(Remove thermal tape
liner on installation)
Ensure correct alignment
of fan sink, mounting clip,
and mounting socket
Chapter 2. Installing options
13