IBM eServer 342 xSeries Installation Manual page 21

3. Remove the cover.
4. Determine which expansion slot you will use for the adapter.
5. Remove the expansion-slot cover.
6. Place the adapter, component-side up, on a flat, static-protective surface.
7. Set any jumpers or switches as described by the adapter manufacturer.
8. Install the adapter.
9. Connect any needed cables to the adapter.
10. If you have other options to install, install them now. Otherwise, install the cover
and proceed to "Cabling the server" on page 19.
The following illustration shows the rerouting of the SCSI cable if you install a
™
ServeRAID adapter.
SCSI
connector A (J24)
Chapter 2. Installing options
9