Table of Contents
Advertisement
Getting Started
Power requirements
WARNING: To ensure proper grounding of the server and avoid a possible fire
hazard, only use the power cable provided with the server.
The EPS and EPS-R power supply units have 6.3 amp and 10 amp over-current
protective circuits, respectively. Before plugging the power cable into a wall outlet—
particularly if the server is mounted in a rack—make sure the AC power source and the
over-current protector (circuit breaker current rating) are sufficient to handle the
requirements of the server and its connected peripheral devices.
The current rating of the server is either 3.6 amps (EPS) or 4 amps (EPS-R). To ensure a
continuous supply of power to the server, Toshiba recommends the use of an
uninterruptible power supply (UPS).
If you have questions about the wiring of your AC power source, consult an authorized
electrician.
Front of the server
Upper door - The upper door allows access to the indicators, switches, device bay,
CD-ROM drive, and floppy disk drive.
Front door panel - The front door panel allows access to the hard disk drives and the side
panel lock.
Front panel lock - Rotating the panel lock releases the access panel, allowing you to
remove the panel and gain access to the server's internal components. The Side Panel
Lock is illustrated on the following page.
Upper door
Front panel lock
Front door panel
Limited access
24
Power requirements
No access
Full access
Advertisement
Table of Contents
