Table of Contents
Advertisement
Hardware Diagnostics
[ TEST PARAMETER ]
01. Go to Test
02. Test Loop
03. Error Stop
TEST PARAMETER Screen for 01. DIAGNOSTIC TEST
1
Select one of the following, using the arrow keys:
01. Go to Test
Select this option to start the test.
If you need to pause or stop (depending on the test) the test program, press <Ctrl> +
<Break>. Press <Esc> to return to the Diagnostic Test Menu.
02. Test Loop
Select YES to increment the pass counter each time the test cycle ends and to
restart the test cycle.
Select NO to return to the HW Diagnostics Program Main Menu after the test is
completed.
03. Error Stop
Select YES to stop the test program when an error is detected.
Select NO to keep the test running even when an error is detected.
Detected errors will be displayed in the Log Utilities. Refer to
131.
2
Press Enter.
: NO
: YES
HW Diagnostics Program Main Menu
Log Utilities
118
on page
Advertisement
Table of Contents
