Table of Contents
Advertisement
Connecting Hardware Devices
4
Connect the SCSI cable to the SCSI connector on the RAID controller. Connect the
SCSI cable to channel 1 when installing a RAID card that has two internal hard disk
drive connectors. For more information, refer to the user's guide that came with the
RAID controller.
Connecting the SCSI cable
5
Reinstall the access panel, reconnect all signal and power cables, then turn on the
server. For instructions, read steps 7 through 10 in
53.
6
Install the RAID card's configuration software, then set up the disk array (RAID). For
instructions, refer to the user's guide that came with the RAID controller.
Expansion cards
Maintenance overview
95
on page
Advertisement
Table of Contents
