Table of Contents
Advertisement
Server Setup Tool
7
Insert a blank diskette, and click OK.
8
After creating the diskettes, you need to label them. To check label descriptions,
select Detail and then Create Floppy Disks. For more information, refer to the SST
online Help.
Post Installation (Windows 2000)
If you have finished the Windows 2000 installation:
1
Start Windows 2000 Server and log on as the Administrator (or a user having
equivalent rights).
2
Run Date/Time Properties by clicking Start, point to Settings, then Control panel,
and double-click Date/Time.
3
Click the Time Zone tab.
4
Check that the current Time Zone setting is correct. If incorrect, select the correct
setting and click OK.
Setting up the Active Directory (to make the server a domain
controller)
If you installed the TCP/IP protocol and want to designate the server as a domain
controller in your network, you must install Active Directory. For more information, refer to
the Windows 2000 Server Help.
Post Installation (Windows NT 4.0)
If you have finished the Windows NT installation:
1
Start Windows NT Server 4.0 and log on as the Administrator (or a user having
equivalent rights).
2
Run Date/Time Properties by clicking Start, point to Settings, then Control panel,
and double-click Date/Time.
3
Click the Time Zone tab.
4
Check that the current Time Zone setting is correct. If incorrect, select the correct
setting and click OK.
Installing the Windows NT Service Pack
For drivers and software to work correctly, you must install the Windows NT Service Pack
(above Service Pack 6).
167
Starting SST
Advertisement
Table of Contents
