Table of Contents
Advertisement
O P E R A T I N G Y O U R V E H I C L E
In AutoStick mode, the transmission will shift up or down when (+/-) is manually selected
by the driver (using the shift lever, or the shift paddles [if equipped]), unless an engine
lugging or overspeed condition would result. It will remain in the selected gear until
another upshift or downshift is chosen, except as described below.
• In temporary AutoStick mode (shift lever in DRIVE), the transmission will automatically
shift up when maximum engine speed is reached. If the accelerator is fully depressed,
the transmission will downshift when possible (based on current vehicle speed and
gear, except 6.2L and 6.4L models). Lack of accelerator pedal activity will cause the
transmission to revert to automatic operation.
• If normal AutoStick mode is engaged (shift lever in MANUAL position), manual gear
selection will be maintained until the shift lever is returned to DRIVE, or as described
below. The transmission will not upshift automatically at redline in this mode, nor will
downshifts be obtained if the accelerator pedal is pressed to the floor.
• The transmission will automatically downshift as the vehicle slows (to prevent engine
lugging) and will display the current gear.
• The transmission will automatically downshift to first gear when coming to a stop. After
a stop, the driver should manually upshift (+) the transmission as the vehicle is
accelerated.
• You can start out, from a stop, in first or second gear. Tapping (+) (at a stop) will allow
starting in second gear. Starting out in second gear can be helpful in snowy or icy
conditions.
• If a requested downshift would cause the engine to over-speed, that shift will not occur.
• The system will ignore attempts to upshift at too low of a vehicle speed.
• Holding the (-) paddle depressed (if equipped), or holding the shift lever in the (-)
position, will downshift the transmission to the lowest gear possible at the current
speed.
• Transmission shifting will be more noticeable when AutoStick is engaged.
• The system may revert to automatic shift mode if a fault or overheat condition is
detected.
To disengage AutoStick mode, return the shift lever to the DRIVE position, or press and
hold the (+) shift paddle (if equipped, and the shift lever is already in DRIVE) until "D" is
once again indicated in the instrument cluster. You can shift in or out of the AutoStick
mode at any time without taking your foot off the accelerator pedal.
Do not downshift for additional engine braking on a slippery surface. The drive wheels
could lose their grip and the vehicle could skid, causing a collision or personal injury.
64
WARNING!
Advertisement
Table of Contents
