Table of Contents
Advertisement
W H A T T O D O I N E M E R G E N C I E S
7. Remove the lug nuts and tire.
8. Mount the spare tire.
Be sure to mount the spare tire with the valve stem facing outward. The vehicle could
be damaged if the spare tire is mounted incorrectly.
NOTE:
• For vehicles so equipped, do not at-
tempt to install a center cap or wheel
cover on the compact spare.
• Refer to "Compact Spare Tire" and to
"Limited-Use Spare" under "Tires—
General Information" in "Starting and
Operating" for additional warnings,
cautions, and information about the
spare tire, its use, and operation.
9. Install the lug nuts with the cone shaped
end of the lug nut toward the wheel.
Lightly tighten the lug nuts.
To avoid the risk of forcing the vehicle off the jack, do not tighten the lug nuts fully until
the vehicle has been lowered. Failure to follow this warning may result in personal
injury.
10. Lower the vehicle to the ground by turning the jack handle counterclockwise.
11. Finish tightening the lug nuts. Push down on the wrench while at the end of the
handle for increased leverage. Tighten the lug nuts in a star pattern until each nut has
been tightened twice. The correct tightness of each lug nut is 130 ft-lbs (176 N·m).
If in doubt about the correct tightness, have them checked with a torque wrench by
your authorized dealer or service station.
12. Stow the jack, tools and flat tire. Make sure the base of the jack faces the front of the
vehicle before tightening down the fastener.
A loose tire or jack thrown forward in a collision or hard stop could endanger the
occupants of the vehicle. Always stow the jack parts and the spare tire in the places
provided. Have the deflated (flat) tire repaired or replaced immediately.
172
CAUTION!
Installing Compact Spare
WARNING!
WARNING!
Advertisement
Table of Contents
