Table of Contents
Advertisement
O P E R A T I N G Y O U R V E H I C L E
To Deactivate
A soft tap on the brake pedal, pushing the CANCEL button, or normal brake pressure while
slowing the vehicle will deactivate the Electronic Speed Control without erasing the set
speed from memory.
Pushing the ON/OFF button or turning the ignition switch OFF erases the set speed from
memory.
To Resume Speed
To resume a previously set speed, push the RES (+) button and release. Resume can be
used at any speed above 20 mph (32 km/h).
To Vary The Speed Setting
To Increase Speed
When the Electronic Speed Control is set, you can increase speed by pushing the SET +
button.
The drivers preferred units can be selected through the instrument panel settings if
equipped. Refer to "Understanding Your Instrument Panel" in the Owner's Manual on the
DVD for more information. The speed increment shown is dependant on the chosen speed
unit of U.S. (mph) or Metric (km/h):
U.S. Speed (mph)
• Pushing the SET + button once will result in a 1 mph increase in set speed. Each
subsequent tap of the button results in an increase of 1 mph.
• If the button is continually pushed, the set speed will continue to increase until the
button is released, then the new set speed will be established.
Metric Speed (km/h)
• Pushing the SET + button once will result in a 1 km/h increase in set speed. Each
subsequent tap of the button results in an increase of 1 km/h.
• If the button is continually pushed, the set speed will continue to increase until the
button is released, then the new set speed will be established.
53
Advertisement
Table of Contents
