Dodge Charger 2016 User Manual page 37

4. Within five seconds, push and release the MEMORY button 1 or 2. The Drivers
Information Display (DID) will display which memory position has been set.
NOTE:
• Memory profiles can be set without the vehicle in PARK, but the vehicle must be in
PARK to recall a memory profile.
• To set a memory profile to your RKE transmitter, refer to "Linking And Unlinking The
Remote Keyless Entry Transmitter To Memory" in this section.
Linking And Unlinking The Remote Keyless Entry Transmitter To Memory
Your RKE transmitters can be programmed to recall one of two pre-programmed memory
profiles by pushing the UNLOCK button on the RKE transmitter.
NOTE:
Before programming your RKE transmitters you must select the "Memory To FOB" or
"Personal Settings Linked To Fob" feature through the Uconnect system screen. Refer to
"Uconnect Settings" in "Understanding Your Instrument Panel" for further information.
To program your RKE transmitters, perform the following:
1. Place the vehicles ignition to the OFF position.
2. Select desired memory profile (1) or (2). The system will recall any stored settings for
this profile. Wait for the system to complete the memory recall before continuing to
Step 3.
NOTE:
If a memory profile has not already been set, refer to "Programming The Memory Feature"
in this section for instructions on how to set a memory profile.
3. Once the profile has been recalled, push and release the SET (S) button on the
memory switch, then push and release button (1) or (2) accordingly. "Memory Profile
Set" (1 or 2) will display in the Drivers Information Display (DID).
4. Push and release the LOCK button on the RKE transmitter within 10 seconds.
NOTE:
Your RKE transmitters can be unlinked from your memory settings by pushing the SET (S)
button, and within 10 seconds, followed by pushing the UNLOCK button on the RKE
transmitter.
G E T T I N G S T A R T E D
35