Table of Contents
Advertisement
Reactive Head Restraints — Front Seats
The front driver and passenger seats are equipped with Reactive Head Restraints (RHR).
In the event of a rear impact the RHRs will automatically extend forward minimizing the
gap between the back of the occupants head and the RHR.
The RHRs will automatically return to their normal position following a rear impact. If the
RHRs do not return to their normal position see your authorized dealer immediately.
To raise the head restraint, pull upward on the head restraint. To lower the head restraint,
push the adjustment button located at the base of the head restraint and push downward
on the head restraint.
NOTE:
To remove the head restraint, raise it as far as it can go then push the release button and
the adjustment button at the base of each post while pulling the head restraint up. To
reinstall the head restraint, put the head restraint posts into the holes and push
downward. Then adjust the head restraint to the appropriate height.
• A loose head restraint thrown forward in a collision or hard stop could cause serious
injury or death to occupants of the vehicle. Always securely stow removed head
restraints in a location outside the occupant compartment.
• ALL the head restraints MUST be reinstalled in the vehicle to properly protect the
occupants. Follow the re-installation instructions above prior to operating the
vehicle or occupying a seat.
• Do not place items over the top of the Reactive Head Restraint, such as coats, seat
covers or portable DVD players. These items may interfere with the operation of the
Reactive Head Restraint in the event of a collision and could result in serious injury
or death.
Rear Head Restraints
The center head restraint has two adjustable positions, up or down. When the center seat
is being occupied the head restraint should be in the raised position. When there are no
occupants in the center seat the head restraint can be lowered for maximum visibility for
the driver.
To raise the head restraint, pull upward on the head restraint. To lower the head restraint,
push the adjustment button located at the base of the head restraint and push downward
on the head restraint.
NOTE:
• The head restraint should only be removed by qualified technicians, for service
purposes only. If the center rear head restraints requires removal, see your authorized
dealer.
• The outboard head restraints are not adjustable.
G E T T I N G S T A R T E D
WARNING!
31
Advertisement
Table of Contents
