Dodge Charger 2016 User Manual page 38

G E T T I N G S T A R T E D
Memory Position Recall
NOTE:
The vehicle must be in PARK to recall memory positions. If a recall is attempted when the
vehicle is not in PARK, a message will display in the Drivers Information Display (DID).
To recall the memory settings for driver 1, push MEMORY button number 1 on the driver's
door or the UNLOCK button on the RKE transmitter linked to memory position 1.
NOTE:
If the vehicle is equipped with Passive Entry, the memory settings will be recalled with a
Passive Entry Unlock into the driver's door using the Key Fob linked to position 1.
To recall the memory setting for driver 2, push MEMORY button number 2 on the driver's
door or the UNLOCK button on the RKE transmitter linked to memory position 2.
NOTE:
If the vehicle is equipped with Passive Entry, the memory settings will be recalled with a
Passive Entry Unlock into the driver's door using the Key Fob linked to position 2.
A recall can be cancelled by pushing any of the MEMORY buttons (S, 1, or 2) on the
driver's door during a recall. When a recall is cancelled, the driver's seat, adjustable pedals
(if equipped), and power tilt and telescopic steering column (if equipped) stop moving. A
delay of one second will occur before another recall can be selected.
Easy Entry/Exit Seat
This feature provides automatic driver seat positioning to enhance driver mobility when
entering and exiting the vehicle.
The distance the driver seat moves depends on where you have the driver seat positioned
when you cycle the vehicle's ignition to the OFF position.
• When you cycle the vehicle's ignition to the OFF position, the driver seat will move
about 2.4 inches (60 mm) rearward if the driver seat position is greater than or equal
to 2.7 inches (67.7 mm) forward of the rear stop. The seat will return to its previously
set position when you cycle the vehicle's ignition to the ACC or RUN position.
• The Easy Entry/Easy Exit feature is disabled when the driver seat position is less than
0.9 of an inch (22.7 mm) forward of the rear stop. At this position, there is no benefit
to the driver by moving the seat for Easy Exit or Easy Entry.
Each stored memory setting will have an associated Easy Entry and Easy Exit position.
NOTE:
The Easy Entry/Exit feature is not enabled when the vehicle is delivered from the factory.
The Easy Entry/Exit feature is enabled (or later disabled) through the programmable
features in the Uconnect system. Refer to "Uconnect Settings/Customer Programmable
Features" in "Understanding Your Instrument Panel" in the Owner's Manual on the DVD
for further information.
36