Table of Contents
Advertisement
G E T T I N G S T A R T E D
Memory Seat
This feature allows the driver to store up to two different memory profiles for easy recall
through a memory switch. Each memory profile contains desired position settings for the
driver seat, side mirrors, adjustable pedals (if equipped), and power tilt and telescopic
steering column (if equipped) and a set of desired radio station presets. Your Remote
Keyless Entry (RKE) transmitter can also be programmed to recall the same positions
when the UNLOCK button is pushed.
NOTE:
If your vehicle is equipped with two RKE transmitters, one RKE transmitter can be linked
to memory position 1 and the other transmitter can be linked to memory position 2.
The memory seat switch is located on the driver's door trim panel. The switch consists of
three buttons: The (S) button, which is used to activate the memory save function and the
(1) and (2) buttons which are used to recall either of two pre-programmed memory
profiles.
Programming The Memory Feature
NOTE:
Saving a new memory profile will erase an existing profile from memory.
To create a new memory profile, perform the following:
1. Place the vehicles ignition to the ON/RUN position.
2. Adjust all memory profile settings to desired preferences (i.e., seat, side mirror,
adjustable pedals [if equipped], power tilt and telescopic steering column [if
equipped], and radio station presets).
3. Push and release the SET (S) button on the memory switch.
34
Memory Seat Switches
Advertisement
Table of Contents
