Bulb Replacement - Sym RS-50 Service Manual

15. ELECTRICAL EQUIPMENT

Bulb Replacement

Headlight/position light
Remove front cover.
Remove the rubber boot.
Press down the bulb spring locker and then
remove the locker with turning it in CCW motion.
Replace the bulb with new one if necessary.
Caution
Do not touch the bulb surface with fingers
because the bulb will create hot-spot so that
let it be burnt. It has to be package with
cloth or wear glove as installing.
Wipe the bulb with cloth to prevent from
damaged if the bulb be touched by hands.
Install the bulb in reverse order of removal.
Connect power to check if the bulb has been
installed properly after installation.
Please conduct the headlight beam adjustment job
if replace the headlight bulb.
The headlight beam adjustment
Turn the screw to right or left to adjust the high or
low beam of headlight.
Caution
This outer cover of headlight is a fixed type so
that the lamp seat will be moved only when
adjusting.
15-20
This chapter Contents
Headlight
Adjust Screw
Position light
Rubber boot