Sym RS-50 Service Manual page 73

7. "V" TYPE BELT DRIVE SYSTEM/KICK-STARTER
Installation of Clutch/Driven Pulley
Assembly
Install new oil seal and O-ring onto sliding pulley.
Apply with specified grease to lubricate the inside
of sliding pulley.
Install sliding pulley onto driven pulley.
Install guide pin and guide pin roller.
Install socket.
Install driven pulley, spring and clutch into clutch
spring compressor, and press down the assembly
by turning manual lever until mounting nut that can
be installed.
Hold the compressor by bench vise and tighten
the mounting nut to specified torque with clutch
nut wrench.
Remove the clutch spring compressor.
Torque value: 5.0~6.0kgf-m
Install clutch/driven pulley and drive belt onto drive
shaft.
7-14
This chapter Contents
Oil seal
O-ring
Sliding pulley
O-ring
Mounting nut
Specified grease
Oil seal
Guide pin
or
Guide pin roller
Guide pin
Socket
Clutch nut
wrench
Clutch spring
compressor