Photometric Chart; Installation; Troubleshooting - ADJ INNO COLOR BEAM QUAD 7 User Instructions

Inno Color Beam Quad 7
Inno Color Beam Quad 7
Stand By Blackout the unit
Function 1. Sync. Strobe
2. Async strobe
3. Sound Strobe
Mode Sound
(LED OFF) (LED Slow Blinking)
Inno Color Beam Quad 7
The unit should be mounted using a mounting clamp (not provided),
affixing it to the mounting bracket that is provided with the unit.
Always ensure that the unit is firmly fixed to avoid vibration and slip-
ping while operating. Always ensure that the structure to which you
are attaching the unit is secure and is able to support a weight of 10
times the unit's weight. Also, always use a safety cable that can hold
12 times the weight of the unit when installing the fixture.
The equipment must be installed by a professional, and it must be
installed in a place where it is out of the reach of people's grasp.
ADJ Products, LLC - www.adj.com - Inno Color Beam Quad 7 User Manual Page 18

Photometric Chart

UC3 Control
Show 1. Pan index Fade Speed
1-4 2. Tilt index 1. Fast
3. Dimmer 2. Middle
3. Slow
Show Show
(LED Fast Blinking)

Installation

Inno Color Beam Quad 7
With this feature you can connect the fixtures to one another
using the IEC input and output sockets. The quantity that can be
connected is 3 fixtures maximum for 120V, and 5 fixtures maxi-
mum for 240V. After the maximum fixtures has been reached you
will need to use a new power outlet. They must be the same fix-
tures. DO NOT mix fixtures.
Inno Color Beam Quad 7
Locate and remove the unit's power cord. Once the cord has been
removed located the fuse holder located inside the power socket.
Insert a flat-head screw driver into the power socket and gently pry out
the fuse holder. Remove the bad fuse and replace with a new one. The
fuse holder has a built-in socket for a spare fuse be sure not to confuse
the spare fuse with active fuse.
Inno Color Beam Quad 7
Due to fog residue, smoke, and dust cleaning the internal and exter-
nal optical lenses must be carried out periodically to optimize light
output.
LED ON
1. Use a soft cloth to wipe down the outside casing.
Cleaning frequency depends on the environment in which the fixture
operates (i.e. smoke, fog residue, dust, dew).
Inno Color Beam Quad 7
Listed below are a few common problems the user may encounter,
with solutions.
Unit not responding to DMX:
1. Check that the DMX cables are connected properly and are
wired correctly (pin 3 is "hot"; on some other DMX devices
pin 2 may be 'hot'). Also, check that all cables are connected
to the right connectors; it does matter which way the inputs
and outputs are connected.
Unit does not respond to sound:
1. Quiet or high pitched sounds will not activate the unit.
If problems are not resolved; Contact ADJ Products, LLC for service.
1-800-322-6337
ADJ Products, LLC - www.adj.com - Inno Color Beam Quad 7 User Manual Page 19
Power Cord Daisy Chaining
Fuse Replacement
Cleaning

Troubleshooting