Page 3
C O N T E N T S General Information Key Features | Warranty Returns Limited Warranty (USA Only) IP65 Rated Safety Guidelines Overview - Flight Case Overview - Lighting Fixture DMX Addressing Wireless Setup (Aria) UC IR Remote Installation In-Case Charging System Menu English...
Page 4
G E N E R A L I N F O R M AT I O N Introduction: Congratulations on your purchase of the ADJ Mirage Q IP! This device is battery- operated, IP65-rated, RGBA LED chrome uplight, and has been designed to perform reliably for years when the guidelines in this booklet are followed.
Page 5
IP65 Outdoor Rated • 15 Degree Beam Angle • 4-touch button OLED display on rear panel • Built-in wireless DMX: Up to 2,500 feet (760M) when used with ADJ’s wireless transceiver • 64 built-in Color Macros • Flicker Free Operation •...
Page 6
All shipping charges must be pre-paid. If the requested repairs or service (including parts replacement) are within the terms of this warranty, ADJ Products, LLC will pay return shipping charges only to a designated point within the United States. If the entire instrument is sent, it must be shipped in its original package. No accessories should be shipped with the product.
Page 7
10,000-hours. This is a prophylactic measure intended to keep the unit running as cool as possible, insuring proper function of all internal components. A complete service breakdown is available, please contact service@adj.com for any needed parts or manuals.
Page 8
S A F E T Y G U I D E L I N E S For Your Own Personal Safety, Please Read and Understand This Manual Completely Before You Attempt To Install Or Operate This Unit! • Be sure to save the packing carton in the unlikely event the device may have to be returned for ser- vice.
Page 9
S A F E T Y G U I D E L I N E S FLIGHT CASE LID When opening the flight case, the lid must be locked in place manually. The lid support prop is located on the right-hand side of the flight case, near the power cable storage compartment. The lower end of the prop is fixed to the flight case, and the disconnected upper end contains a cut-out groove.
Page 10
O V E R V I E W FLIGHT CASE Power Fuse Power Charging Indicator* Lid Latches BLACK Locking Casters *Note: Charge indicator is red when charging, and green when complete. Charge indicator on the case displays charge status of the entire six-unit set. For individual charge status, please refer to the charge indicator on each individual unit.
Page 12
D M X A D D R E S S I N G All fixtures should be given a DMX starting address when operating with a DMX controller, in order to ensure that the correct fixture responds to the correct control signal. This digital starting address is the channel number from which the fixture starts to “listen”...
Page 13
W I R E L E S S S E T U P ( A R I A ) These devices do not feature physical DMX connector ports. Therefore, in order to utilize DMX control, the user must first set up the devices to run wireless DMX control. Follow the directions below to configure wireless DMX control: 1.
Page 14
W I R E L E S S S E T U P ( A R I A ) There are many factors that can affect and/or interrupt a wireless signal, including walls, glass, metal, objects, and people. Therefore, the following guidelines are recommended in order to maximize the chances of having a clear path for the wireless signal to reach the device: •...
Page 15
U C I R R E M O T E The unit can only be controlled when it has been set to Primary mode. The unit will NOT respond to commands when it has been set to Secondary mode. When using the remote to control multiple units that are operating in primary/secondary mode, follow these steps to set up the units: 1.
Page 16
I N S TA L L AT I O N IP RATING The Mirage Q IP is IP65 rated. It is completely dust tight, and is protected against low-pressure directed jets of water from any direction. Note that the charging base in NOT protected against moisture or dust intrusion of any kind, and should be used only in a dry, indoor setting! FLAMMABLE MATERIAL WARNING! Keep device a minimum of 5.0 feet (1.5m) away from flammable material and/or pyrotechnics.
Page 17
I N S TA L L AT I O N CLAMP INSTALLATION The Mirage Q IP features a mounting clamp attachment point on the side of the device (see the illustration below). When mounting the fixture to a truss or any other suspended or overhead installation, be sure to secure appropriately rated clamps (not included) to the clamp attachment point.
Page 18
I N S TA L L AT I O N KICKSTAND FOR FLOOR PLACEMENT The Mirage Q IP can also be placed on the floor to provide an uplighting display, and features a retractable kickstand that allows the device to be angled in the direction of the desired display. Make sure that the rubber cap is secured over the charge port to maintain the device’s IP65 rating.
Page 19
I N S TA L L AT I O N KENSINGTON KEY SLOT The device features a slot for a Kensington-type security device that can be used to prevent theft. The key slot is located near the bottom of one of the device’s feet, as shown in the illustration below. Be sure to attach the security device to a sturdy, fixed anchor point.
Page 20
4. Place an ADJ Mirage Q IP device in any of the device slots in the flight case. Up to 6 devices can be accommodated. The charge indicator located beside the power ports will illuminate to indicate that your device is charging.
Page 21
S Y S T E M M E N U This fixture includes an easy to navigate control panel display, from which all necessary settings and adjustments can be made. Press the MODE button to scroll through the main menu options, then press SET UP to select the currently displayed option.
Page 22
S Y S T E M M E N U - E N G L I S H MAIN MENU OPTIONS / VALUES (Default Settings in BOLD) VALUES/DESCRIPTION DMX Address 001 - 512 4ch, 6ch, 7ch, 8ch, 9Ach, 9Bch, 10ch, 11ch, 11ch, DMX Channel Mode 12ch, 15ch, 18ch DMX Settings...
Page 23
S Y S T E M M E N U - E N G L I S H MAIN MENU OPTIONS / VALUES (Default Settings in BOLD) DESCRIPTION 000-255 Green 000-255 Blue 000-255 Amber 000-255 Manual Color Macros 000-255 Control Color Temperature 000-255 2300-9900K Linear...
Page 24
S Y S T E M M E N U - S PA N I S H MAIN MENU OPTIONS / VALUES (Default Settings in BOLD) DESCRIPTION Direccion DMX 001 - 512 4ch, 6ch, 7ch, 8ch, 9Ach, 9Bch, 10ch, 11ch, 11ch, Modo Canales DMX 12ch, 15ch, 18ch Configuracion...
Page 25
S Y S T E M M E N U - S PA N I S H MAIN MENU OPTIONS / VALUES (Default Settings in BOLD) DESCRIPTION Rojo 000-255 Verde 000-255 Azul 000-255 Ambar 000-255 Macros de Color 000-255 Manual Temperatura de Color Control 000-255...
Page 26
D I M M E R C U R V E S DIMMER 100% Time (ms) 0 Sec Rise Time Down Time 0 sec Fade Time 1 sec Fade Time Dimming Curve Ramp Effect Rise Time (ms) Down Time (ms) Rise Time (ms) Down Time (ms) Standard (default) Stage 1100...
Page 27
D M X T R A I T S CHANNEL VALUE FUNCTION 4Ch 6Ch 7Ch 8Ch 9ACh 9BCh 10Ch 11Ch 12Ch 15Ch 18Ch 0-255 All Red, 0~100% 0-255 All Red Fine 16-bit 0-255 All Green, 0~100% 0-255 All Green Fine 16-bit 0-255 All Blue, 0~100% 0-255...
Page 28
D M X T R A I T S CHANNEL VALUE FUNCTION 4Ch 6Ch 7Ch 8Ch 9ACh 9BCh 10Ch 11Ch 12Ch 15Ch 18Ch Dim Curves 0-20 Linear Square 21-40 Inv. Squa 41-60 61-80 S. Curve 81-255 No Function Refresh Rates 0-15 Default to Unit Setting 16-30...
Page 29
C O L O R M A C R O S RGBW COLOR INTENSITY RGBW COLOR INTENSITY Color DMX Value Color DMX Value RED GREEN BLUE RED GREEN BLUE WHITE Color Macro 33 129-132 Color Macro 1 Color Macro 34 133-136 Color Macro 2 Color Macro 35 137-140 Color Macro 3...
Page 30
C O L O R T E M P E R AT U R E https://www.luxalight.eu/en/cie-convertor Colors shown are an approximate representation. DMX VALUE COLOR TEMPERATURE (K) DMX VALUE COLOR TEMPERATURE (K) 2300 6200 6300 2400 2500 6400 2600 6500 2700 6600 2800...
Page 31
I R D E FA U LT R G B A VA L U E S BUTTON GREEN BLUE AMBER...
Page 32
Regular inspections are recommended to ensure proper function and extended life. There are no user serviceable parts inside this fixture. Please refer all other service issues to an authorized ADJ service technician. Should you need any spare parts, please order genuine parts from an authorized ADJ dealer.
Page 33
T O R Q U E S E T T I N G S IN ORDER TO MAINTAIN THE IP65 RATING ON THE LIGHTING FIXTURES, ALL SCREWS MUST BE TIGHTENED TO THE FOLLOWING TORQUE SPECIFICATION USING A TORQUE DRIVER. These screws must be torqued to 11.3 lb-in (13.0 kg-cm). TORQUE DRIVERS (Recommended): UTICA TS-30 (shown) ALTERNATE DRIVERS: •...
Page 34
B AT T E R Y L I F E Following any software update, the battery life information setting must be reset before it will display accurate information. This can be done by following the steps below: 1. Navigate to Battery > Operation Mode in the system menu and make sure that the device is set to either Standard 6 or Saver 10.
Page 35
D I M E N S I O N A L D R AW I N G S MIRAGE Q IP MIRAGE Q IP FLIGHT CASE 26.4in. [671mm] 18.2in. [461mm] 25.7in. [654mm] 17.4in. [443mm]...
Page 36
• Built-in kickstand to angle fixture when sitting on the floor • 4-touch button OLED display on rear panel • Built-in WiFLY EXR wireless DMX: Up to 2,500 feet (760M) when used with ADJ’s Specifications subject to change without notice.
Page 37
F C C S TAT E M E N T This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Need help?
Do you have a question about the MIRAGE Q6 PAK BLACK and is the answer not in the manual?
Questions and answers