Output Channels - Yamaha rivage pm10 Operation Manual

Output Channels  Mixing Engine section

Output Channels

Mixing Engine section
MIX bus
MIX1-72
INSERT 1
PLUG-IN 1 PLUG-IN 2 PLUG-IN 3 PLUG-IN 4
INSERT 2
4
INSERT 1
DIMMER
8 BAND
HPF LPF
DYNAMICS
PEQ
PRE PRE PRE
FILTER EQ DYNA
TALKBACK
2 KEY IN
1
One can be selected within the
1
FILTER
• HPF slope
You can specify -6 dB/oct, -12 dB/oct, -18 dB/oct, or -24 dB/oct.
• LPF slope
You can specify -6 dB/oct or -12 dB/oct.
2 EQ
• 8 BAND PEQ
This is an eight-band parametric EQ. The following EQ types can be selected: PRECISE,
AGGRESSIVE, SMOOTH, or LEGACY. Two sets of EQ parameter settings (A and B) can be
saved for convenient comparison. The FREQUENCY parameter of each band is normally set
in 1/12 octave steps, but if you need more precise adjustment, you can set it in 1/24 octave
steps. Band 1 can be switched to L SHELF (Low Shelving) and band 8 can be switched to H
SHELF (High Shelving).
The selectable EQ types are the same as for input channels
INSERT 2
PLUG-IN 1 PLUG-IN 2 PLUG-IN 3 PLUG-IN 4
LEVEL/
DCA1-24
ON
To
DELAY
OUTPUT
Max.1000ms
PRE POST POST PATCH
DELAY BALANCE
FADER ON
3 5
area
(page 18).
3 DYNAMICS
One dynamics processor module is provided. You can select a dynamics function from six types,
including GATE and COMP. Two types of compressor are provided: LEGACY COMP and
COMP 260. Two sets of dynamics parameter settings (A and B) can be saved for convenient
comparison.
The selectable dynamics types are the same as for input channels
• KEY IN SOURCE
Selects the source of the key-in signal.
In addition to SELF, the key-in signal can also be selected directly from another channel or
input patch. You can use an HPF, BPF, or LPF as a KEY IN FILTER.
4
INSERT
Two inserts are provided: Insert 1 and Insert 2. In each insert, you can insert up to four plug-ins/
GEQ/PEQ/external devices (via the I/O jacks).
Each insert point can be freely specified independently.
5
DELAY
Up to 1000 msec of delay is provided on each channel. The position at which the delay is
inserted is fixed at pre-fader. You can select the delay time unit from the following: meter, feet,
sample, msec, frame, depending on your application.
21
FAQ
CONTENTS
(page 19).
RIVAGE PM10 Operation Manual