Laser Safety - Datalogic DS6400 Quick Reference Manual

DS6400 QUICK GUIDE
COMPLIANCE
See the DS6400 Reference Manual for the Declaration of Conformity.

LASER SAFETY

1
Figure A
1 Laser Beam Output Window
The scanner is classified as a Class 2 laser product according to EN 60825-1 regulations and as a Class II laser
product according to CDRH regulations.
Disconnect the power supply when opening the device during maintenance or installation to avoid exposure to
hazardous laser light.
There is a safety device which allows the laser to be switched on only if the motor is rotating above the threshold
for its correct scanning speed.
The laser beam can be switched off through a software command (see also the Genius™ Help On-Line).
LASER RADIATION IS EMITTED FROM THIS APERTURE
Warning and Device Class Label
The laser diode used in this device is classified as a Class 3B laser product according to EN 60825-1 regulations
and as a Class IIIb laser product according to CDRH regulations. Any violation of the optic parts in particular can
cause radiation up to the maximum level of the laser diode (35 mW at 630 ~ 680 nm).
28
2
2 Laser Safety Label
AVOID EXPOSURE
Laser Safety Label for Oscillating Mirror and Standard Models
DS6400
1
Figure B
1 Laser Beam Output Window
AVOID EXPOSURE – LASER LIGHT
IS EMITTED FROM THIS APERTURE
DATALOGIC S.p.A. Via Candini, 2
40012 LIPPO DI CALDERARA DI RENO (BO) ITALY
MANUFACTURED VOLT
JANUARY 2005
MODEL No.
SERIAL No.
This product conforms to the applicable requirements
of 21CFR 1040 at the date of manufacture.
Device Identification Label
2
2 Laser Safety Label
Amp.
15-30 DC 1.5-0.7
N2468