Safety Precautions; Electrical Safety; Laser Safety - Datalogic DX8200 Installation Manual

SAFETY PRECAUTIONS

ELECTRICAL SAFETY

This product conforms to the applicable requirements contained in the European
Standard for electrical safety EN-60950 at the date of manufacture.
This symbol refers to operations that must be performed by qualified personnel
only. Example: opening the device.
This symbol refers to operations where there is danger of electrical shock. Before
opening the device make sure the power cable is disconnected to avoid electric
shock.
For AC models, this device must be installed to a power source equipped with
on/off switch or breaker within range of the operator as protection against
grounding failures.
This device is protected against overloading by correct value fuses. For
protection fuse replacement make sure correct value fuses are installed. See the
fuse selection table in par. 5.2.

LASER SAFETY

The following information is provided to comply with the rules imposed by international
authorities and refers to the correct use of the DX8200 scanner.
Standard Regulations
This scanner utilizes up to 3 low-power laser diodes. Although staring directly at the laser
beam momentarily causes no known biological damage, avoid staring at the beam as one
would with any very strong light source, such as the sun. Avoid that the laser beam hits the
eye of an observer, even through reflective surfaces such as mirrors, etc.
This product conforms to the applicable requirements of both IEC 825-1 and CDRH 21 CFR
1040 at the date of manufacture. The scanner is classified as a Class 2 laser product
according to IEC 825-1 regulations and as a Class II laser product according to CDRH
regulations.
There is a safety device which allows the laser to be switched on only if the motor is rotating
above the threshold for its correct scanning speed.
Use of controls or adjustments or performance of procedures other than
those specified herein may result in exposure to dangerous laser
radiation.
WARNING
ix