Table of Contents
Advertisement
COMPLIANCE
See the DX8200A Reference Manual for the Declaration of Conformity.
LASER SAFETY
The scanner is classified as a Class 2 laser product according to EN60825-1 regulations and as a Class II laser
product according to CDRH regulations.
Disconnect the power supply when opening the device during maintenance or installation to avoid exposure to
hazardous laser light.
There is a safety device, which allows the laser to be switched on only if the motor is rotating above the threshold
for its correct scanning speed.
The laser beam can be switched off through a software command (see also the Genius™ Help On-Line).
CAUTION-CLASS 3B LASER LIGHT WHEN OPEN
AVOID EXPOSURE TO BEAM
LASER LIGHT EMITTED
FROM THIS
APERTURE
Warning and Device Class Label
The laser diodes used in this device are classified as Class 3B laser products according to EN 60825-1 regulations
and as Class IIIb laser products according to CDRH regulations. Any violation of the optic parts in particular can
cause radiation up to the maximum level of the laser diode (30 mW at 630~680 nm).
Warning and Device Class Label
1
LASER LIGHT
DO NOT STARE INTO BEAM
CLASS 2 LASER PRODUCT
MAXIMUM OUTPUT RADIATION 1 mW
EMITTED WAVELENGTH 630~680 nm
TO EN 60825-1:2001
2
1
Figure D
Device Identification Label
2
Datalogic Automation S.r.l. Via Candini, 2
40012 Calderara di Reno - Bologna - Italy
Manufactured
Model No.
Serial No.
This product conforms to the applicable requirements
of 21CFR1040 at the date of manufacture.
Device Identification Label
DX8200A-3002 QUICK GUIDE
Volt
Amp.
11
Advertisement
Table of Contents
