Fluid And Lubricant Specifications; Fuse/Relay/Circuit Breaker Identification - freightliner WALK-IN VAN CHASSIS Operator's Manual

Specifications
Fluid and Lubricant
Specifications
See Table 18.6 for fluid and lubricant specifications.
Component
Front Axle Spindle Pins, Tie Rods, Drag Link,
Intermediate Steering Shaft, Front Brake and
Pedal Shafts, Slip Spline and Universal Joints
Hydraulic Brake Master Cylinder
Brake and Pedal Pivots
Engine
Transmission
Fuel
Disc Brake Caliper Rails
Rear Axle Differential
Hydraulic System Reservoir
Engine Coolant
Fuse/Relay/Circuit Breaker
Identification
NOTE: The fuse/circuit breaker panel is located
under the instrument panel to the left of the
steering column. Circuit breakers protect against
circuit overload. If a circuit becomes overloaded
(usually caused by a short to ground), the circuit
breaker opens, stopping current flow. Auto-reset
breakers are installed. Depending on vehicle
options, fuse/circuit breaker locations may vary
from those shown. A power distribution panel
may also be installed on the vehicle. This panel
houses plug-in fuses and relays. See
and Fig. 18.2.
18.5
Fluid and Lubricant Specifications
Multipurpose Grease Lithium 12 Hydroxy Stearate NLGI No. 2; for
temperatures below 0°F (–18°C), use MIL-G-10924B
Heavy-Duty DOT 3 Brake Fluid
Starplex 2 (lithium soap-based grease)
See Manufacturer's Recommendations
See Manufacturer's Recommendations
Ultralow-Sulfur Diesel Fuel
CMS 20067 (CNG Engines)
HD5 Grade Propane
FCCC No. 4JD623 Brake Caliper Slide Grease
See Manufacturer's Recommendations
Dexron® III ATF or equivalent
50% Water/50% Ethylene Glycol Antifreeze (diesel engines)
50% Water/50% DEX-COOL® Coolant (gasoline and propane engines
only)
Table 18.6, Fluid and Lubricant Specifications
Fig. 18.1
Recommended Fluid or Lubricant