System Board (Emi) Shield - HP proone 400 g2 Maintenance & Service Manual

System board (EMI) shield

The system board shield covers the system board. A latch holds the shield in place. Four screws secure the
shield.
To remove the system board shield:
1. Prepare the computer for disassembly (see
2. Remove the rear port cover (see
3. Remove the stand (see
4. Remove the access panel (see
5. Remove the four screws securing the electromagnetic interference (EMI) shield to the chassis.
6. Push the EMI shield latch toward the center of the computer (1) to release the EMI shield, and then lift
the shield off the computer (2).
To install the system board shield, reverse the removal procedures.
Preparing to disassemble the computer on page
Rear port cover on page
Attaching and removing a stand on page
Access panel on page
23).
24).
28).
System board (EMI) shield
22).
37