Removing An Adjustable-Height Stand; Easel Stand; Attaching An Easel Stand - HP proone 400 g2 Maintenance & Service Manual

Removing an adjustable-height stand

To remove the stand:
1. Prepare the computer for disassembly (see
2. Remove the rear port cover (see
3. Press the release latch under the stand (1).
4. Lift the stand up (2), and then pull the stand hooks out of the computer (3).

Easel stand

Attaching an easel stand

To install the stand:
1. Place the computer face down on a soft flat surface. HP recommends that you set down a blanket, towel,
or other soft cloth to protect the bezel and screen surface from scratches or other damage.
2. Engage the hooks in the top of the stand in the two large holes in the upper part of the back of the
computer (1).
26 Chapter 4 Removal and Replacement Procedures
Preparing to disassemble the computer on page
Rear port cover on page 23).
22).