Webcam Module - HP proone 400 g2 Maintenance & Service Manual

Webcam module

On products that ship with a webcam module, the module is located at the top of the computer beneath the
top trim. It is housed in a metal bracket that is secured with two Phillips screws. The webcam module has one
connector.
To remove the webcam module:
1. Prepare the computer for disassembly (see
2. Remove the rear port cover (see
3. Remove the stand (see
4. Remove the access panel (see
5. Remove the top trim (see
6. Disconnect the cable from the webcam module (1).
7. Remove the two Torx screws (2) that secure the webcam module bracket to the computer.
8. Remove the webcam from the computer.
Preparing to disassemble the computer on page
Rear port cover on page
Attaching and removing a stand on page
Access panel on page
Top trim on page 34).
23).
24).
28).
22).
Webcam module 35