Removing An Easel Stand - HP proone 400 g2 Maintenance & Service Manual

3. Lower the stand onto the computer and press down until it clicks into place (2).

Removing an easel stand

To remove the stand:
1. Prepare the computer for disassembly (see
2. Remove the rear port cover (see
3. Press the release latch under the stand (1).
4. Lift the stand up (2), and then pull the stand hooks out of the computer (3).
Preparing to disassemble the computer on page
Rear port cover on page 23).
Attaching and removing a stand
22).
27