Drive Cable - HP proone 400 g2 Maintenance & Service Manual

Drive cable

The drive cable includes connectors for the optical drive and hard drive, as well as three cables that connect to
the system board..
To remove the drive cable:
1. Prepare the computer for disassembly (see
2. Remove the rear port cover (see
3. Remove the stand (see
4. Remove the access panel (see
5. Remove the system board shield (see
6. Remove the VESA bracket (see
7. Remove the two screws (1) that secure the optical drive connector to the computer.
8. Remove the cables from the clips built into the computer (2).
9. Disconnect the cables from the system board connectors (3).
56 Chapter 4 Removal and Replacement Procedures
Preparing to disassemble the computer on page
Rear port cover on page
Attaching and removing a stand on page
Access panel on page
System board (EMI) shield on page
VESA mounting bracket on page
23).
24).
28).
37).
55).
22).