Serial/Ps2 Board; Remove The Access Panel - HP proone 400 g2 Maintenance & Service Manual

Serial/PS2 board

The serial/PS2 board is located to the left of the rear I/O panel. It is secured with two screws and has one
connected cable.
To remove the serial/PS2 board:
1. Prepare the computer for disassembly (see
2. Remove the rear port cover (see
3. Remove the stand (see
4. Remove the access panel (see
5. Remove the rear I/O panel (see
6. Disconnect the cable (1) from the board.
52 Chapter 4 Removal and Replacement Procedures
Preparing to disassemble the computer on page
Rear port cover on page
Attaching and removing a stand on page
Access panel on page
Rear I/O cover and bottom trim on page
23).
24).
28).
64).
22).