Antennas; Prepare The Computer For Disassembly (See Preparing To Disassemble The Computer - HP proone 400 g2 Maintenance & Service Manual

Antennas

The antennas route from the WLAN module to transceivers at the top of the computer. The transceivers are
secured to the computer with adhesive.
To remove the antennas:
1. Prepare the computer for disassembly (see
2. Remove the access panel (see
3. Remove the system board shield (see
4. Remove the top trim (see
5. Disconnect the antennas from the WLAN module (1).
6. Peel the transceivers off the frame (2).
7. Note the routing path for each antenna for replacement (3).
To install the antenna, reverse the removal procedures.
NOTE: When connecting the antennas cables, be sure to match the numbers on the cable with the same
number printed on the WLAN module.
Preparing to disassemble the computer on page
Access panel on page
System board (EMI) shield on page
Top trim on page 34).
28).
37).
22).
Antennas 45