Attaching and removing a stand
Three stands are available for the computer:
●
Recline stand
●
Adjustable-height stand
●
Easel stand
Recline stand
Attaching a recline stand
To install the stand:
1.
Place the computer face down on a soft flat surface. HP recommends that you set down a blanket, towel,
or other soft cloth to protect the bezel and screen surface from scratches or other damage.
2.
Engage the hooks in the top of the stand in the two large holes in the upper part of the back of the
computer (1).
3.
Lower the stand onto the computer and press down until it clicks into place (2).
Removing a recline stand
To remove the stand:
1.
Prepare the computer for disassembly (see
2.
Remove the rear port cover (see
3.
Press the release latch under the stand (1).
24
Chapter 4 Removal and Replacement Procedures
Preparing to disassemble the computer on page
Rear port cover on page
23).
22).